Amscan helium for 50 balloons

Easy to use and fully recyclable. Gas content is sufficient for up to 50 balloons. Net content: 0.400 cubic meters. Temperature, humidity and atmospheric pressure can influence the floatation time and strength of the balloons. Can be used to inflate latex or foil balloons.

Instructions for use:

1. Turn the green valve until it is fully open. Don't worry, the gas inside is not released yet.
2. Place the end of the balloons over the black rubber valve and hold tightly with your fingers.
3. Press down on the end of the balloon and the black valve of the cylinder, continuing to hold it tightly with your fingers until helium flows into the balloon.
4. Remove the inflated balloon and tie it carefully.
5. Close the green tap until it is completely closed.

Helpful tip: Stretch latex balloons before inflating them.

Contains compressed gas (UN 1046, CAS#7440-59-7). Balloons should always be inflated to the maximum size recommended by the manufacturer. Exceeding this size may cause the balloons to burst and cause damage and injury.

Important:

For your safety, the cylinder must be completely emptied before being discarded. You can do this by unscrewing the inflation end and fully opening the green valve until all remaining gas is released. On the cylinder body, locate a round patch mark opposite the valve. Make a hole here, circle it and label it “Empty”. Important warning: DO NOT REFILL!